Occasionally when using the Draw Cloud tool (under Drawing Markups) I find the need to delete a superfluous handle, or add a handle. I would like to do this without the need of deleting the existing cloud drawing and starting over again.

For example, let's say I selected the tool and began plotting points. These drawings are often polygons with many segments, taking a bit of time and care to construct. As the tool connects the points it leaves a handle to mark the last point, until I complete the drawing by clicking the beginning handle.

Sometimes I fumble-figure the drawing and end up with two points really close to each other, producing an unwanted additional segment of the drawing. My only option is to either cancel the entire drawing and start over, or accept the additional handle and try to make use of it.

I suggest that this tool be modified to enable the user, while making the drawing, to delete the last handle created, or, after completing the drawing, to delete any of the handles. This would facilitate easier revisions of the drawing and save the time and trouble to redo the drawing altogether.

Thanks!